Skip to content
Repair KL
Menu
from RM80 per job

Electrician in Kuala Lumpur from RM80, DB Trip Diagnosis & Installations

Residential fault-finding and electrical fitting installation across KL & Selangor with 15-minute WhatsApp replies and a 90-day workmanship warranty.

  • Reply within 15 minutes, 8am - 9pm
  • 30 day workmanship warranty
  • Price confirmed before work
  • KL and Selangor, same day

Book in 30 seconds

Pick a service and area, then send a ready-made WhatsApp message. No long forms.

Book on WhatsApp

Or just WhatsApp us directly

We reply within 15 minutes, 8am - 9pm. Send a photo of the fault for a sharper quote.

When your distribution board (DB) trips repeatedly in the middle of the night or during heavy Kuala Lumpur thunderstorms, forcing the RCCB lever back up without finding the earth leakage source is a serious shock and fire hazard. Our electricians isolate circuits methodically with insulation resistance testers and clamp meters to pinpoint whether the fault lies in a leaking water heater element, damp outdoor wiring, a faulty appliance or a fatigued breaker.

Alongside fault troubleshooting, we handle everyday residential electrical installations across condos and link houses: hanging DC ceiling fans on rated hooks, cutting and wiring LED downlights into plaster ceilings, replacing melted 20A double-pole water heater switches and swapping cracked 13A power sockets. Every earth conductor is verified for continuity and every terminal screw is torqued firmly to prevent overheating.

We never cut corners on safety: any replacement breaker, socket or cable we supply carries proper SIRIM certification matched to the circuit rating. Every electrical installation and repair we complete is backed by a 90-day workmanship warranty.

What is included

  • Voltage, polarity and earth-continuity verification on every point we install or repair.
  • Insulated terminal connectors, PVC electrical tape and standard mounting screws.
  • Diagnostic instruments including digital clamp meter and insulation resistance tester.
  • Sweeping up gypsum dust beneath downlight cut-outs and fan installations.
  • 90-day workmanship warranty on all terminations, switches and fittings we install.

What is not included

  • Supply cost of fans, light fixtures, water heaters, switches or DB breakers (can be supplied separately).
  • TNB mains meter relocation, single-to-three-phase TNB submissions or street supply faults.
  • Fabricating new concrete slab fan hooks where none exist above plaster ceilings (quoted if needed).
  • Wall plastering and repainting if you request new concealed conduit hacking.

Rates for this job

Price list
JobPrice fromUnitNotes
Ceiling fan installationRM120per fanOn existing wiring point and ceiling hook; fan unit excluded.
Light point or downlight installationRM60per pointFitting installation on existing point; light fixture and new concealed wiring excluded.
Water heater installationRM180per unitReplacement on existing heater switch and water inlet; heater unit excluded.

Prices above are labour only. Parts are quoted separately before work begins.

Get a Quote
Full prices and call-out rates

Common problems we fix

  • Main RCCB earth-leakage switch keeps tripping randomly

    We trace hidden neutral-to-earth or live-to-earth leakage across outdoor garden lights, kitchen circuits and wet-area appliances.

  • 20A water heater or aircond switch feels hot or smells burnt

    Loose copper terminations arc under heavy current; we trim oxidised wire ends and fit a fresh SIRIM-approved 20A double-pole switch.

  • Ceiling fan wobbling, clicking or spinning very slowly

    Sluggish AC fans often just need a fresh run capacitor, while wobbling fans have their mounting bracket, rubber bush and safety cable inspected.

  • Recessed LED downlights flickering or dead across a room

    We match your existing plaster cut-out diameter (4-inch or 6-inch) and colour temperature (3000K warm, 4000K cool or 6500K daylight).

  • Kitchen countertop 13A sockets sparking or losing power

    Kettles, ovens and air fryers wear out cheap socket contacts; we install heavy-duty SIRIM twin sockets and verify ring-circuit health.

  • Vacant possession (VP) condo needing full light and fan fit-out

    We offer itemised whole-unit fit-out rates to wire and hang every downlight, pendant, ceiling fan and water heater in a single coordinated day.

Electrical Safety Notes & Preparing for Your Visit

If your DB board has tripped and refuses to reset, unplug heavy countertop appliances such as kettles, irons, ovens and washing machines, and switch off all 20A water heater and aircond wall switches. Snap a clear photo of your open DB panel showing which breaker dropped and send it to our WhatsApp so our electrician knows your board layout right away.

When buying ceiling fans for a Kuala Lumpur condo, check your floor-to-ceiling height first: standard 9.5-foot condo ceilings need short-pipe baby or low-profile DC fans so spinning blades stay safely above 2.4 metres from the floor. If concrete ceiling drilling is required for new hooks, please arrange a standard weekday work permit with your management office.

Our electrician removes shoes at the door, places rubber-footed insulated ladders on drop cloths to protect timber or tiled floors, and tests every switch and water heater ELCB button in front of you before completion. Settle payment conveniently via cash, DuitNow QR or bank transfer once everything is tested.

Technician testing an electrical circuit with a multimeter
Real job photo slot: neat SIRIM DB breaker replacement and ceiling fan mount
Aircond units being repaired in a workshop

Areas we cover

Also covered: Sentul, Sri Hartamas, Bukit Jalil, Old Klang Road, Damansara, Shah Alam, Klang, Kajang.

Useful guides

Frequently asked questions

Why does my house electricity trip only during heavy rain?

Rain-triggered trips almost always come from moisture seeping into gate pillar lights, porch fittings, outdoor weatherproof sockets or autogate junction boxes. Moisture creates an earth leak that trips the main RCCB; we isolate and reseal or disconnect the faulty outdoor leg so indoor power stays on.

Can you install a ceiling fan where there is currently only a light point?

Electrically yes for remote-controlled fans, but mechanically a ceiling fan must NEVER hang from gypsum board alone. We inspect above the ceiling via a downlight hole or manhole and install a proper concrete anchor bracket or steel support bar onto the slab.

Do you use SIRIM-certified switches, sockets and DB breakers?

Yes. Every replacement socket, 20A heater switch, MCB and RCCB supplied by our team carries SIRIM approval from established brands such as Hager, Schneider, EPS or Maxguard.

How long does it take to install lights and fans for a 3-bedroom condo?

Fitting roughly 15 to 20 LED downlights, 4 ceiling fans and 2 instant water heaters onto existing developer points typically takes a two-person crew 4 to 6 hours within a single day.

Another question? Contact us or WhatsApp 012-227 3341.

Need electrician this week?

Message us on WhatsApp and we will confirm the price and a same-day slot. Reply within 15 minutes, 8am - 9pm.